 |
 |
 |
|
|
|
[Sponsors] | ||||
May 17, 2013, 09:14
|
a problem with cfx!!
|
#1 |
|
New Member
reihaneh
Join Date: May 2013
Posts: 1
Rep Power: 0  |
Hi! I’m a beginner user in cfx and I’m trying to simulate a radiation furnace. I chose transient type because all of the walls are adiabatic and there is a radiation source on 3 of the walls. The radiation simulation type is Monte Carlo and I tried to solve the problem in non buoyant type. The problem is I get velocity rate and it does not remain zero and also every equations converge but momentum equations. Any comments??!
Last edited by reihaneh; May 19, 2013 at 03:38. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ERROR #002100056 CFX FSI problem | Hongdao | CFX | 0 | November 10, 2010 04:58 |
| CFX Mesh Deformation problem | Silmaril | CFX | 7 | October 19, 2010 11:00 |
| CFX Casting problem: Can it be done all in one? | jfasl | CFX | 1 | September 14, 2010 04:14 |
| Fan Modelling Problem in CFX | Jenny | CFX | 8 | September 11, 2007 14:59 |
| CFX 4.4 installation problem | Pandu Sattvika | CFX | 1 | December 1, 2001 05:07 |
Linear Mode
