Overflow - Help me

Roland R · April 16, 2013, 12:37

Hello,

I try to simulate a transient model. The solver starts to calculate but I always get "Overflow" in the 0. time step after 2-3 iterations. Based on these iterations, the residuals are ok. In my opinion, the mesh and the time step size are ok. (I think, if the mesh or the time step value is not ok then the error should be seen only after some time steps in the convergence history.) What can be the problem?

Regards
Roland

ghorrocks · April 16, 2013, 20:28

FAQ: http://www.cfd-online.com/Wiki/Ansys...do_about_it.3F

April 16, 2013, 12:37	Overflow - Help me	#1
Roland R Senior Member Roland Rakos Join Date: Mar 2009 Posts: 131 Rep Power: 17	Hello, I try to simulate a transient model. The solver starts to calculate but I always get "Overflow" in the 0. time step after 2-3 iterations. Based on these iterations, the residuals are ok. In my opinion, the mesh and the time step size are ok. (I think, if the mesh or the time step value is not ok then the error should be seen only after some time steps in the convergence history.) What can be the problem? Regards Roland

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Solution variables goes outside upper limit -how to localize fatal overflow occurance	Dimone	CFX	2	January 21, 2011 07:35
Floating-point Overflow 0xc0000091 causes?	JohnGane1987	Main CFD Forum	0	April 8, 2010 10:53
OVERFLOW and Horizontal Axis Wind Turbine	ntonkin	Main CFD Forum	1	November 19, 2009 02:40
overflow error on linux cluster	steven	CFX	1	March 13, 2007 09:05
linear solver overflow	peggy	CFX	1	February 8, 2001 02:39

April 16, 2013, 20:28		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,872 Rep Power: 144	FAQ: http://www.cfd-online.com/Wiki/Ansys...do_about_it.3F