 |
 |
 |
|
|
|
[Sponsors] | ||||
February 5, 2013, 10:24
|
Boundary condition problem
|
#1 |
|
New Member
Jakub
Join Date: Mar 2011
Location: Slovakia
Posts: 1
Rep Power: 0  |
Hi
When i set boundary to outlet/opening/inlet on selected face ( problem.PNG ) one arrow appears out of selected face. Is it defected mesh or its some kind of ANSYS bug? |
|
|
|
|
|
February 5, 2013, 18:14
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,872
Rep Power: 144 |
Generate a def file and look at it in CFD-Post. If CFD-Post shows the boundaries are set up correctly then do not worry about it. But it might show you have a meshing error which needs fixing.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Impinging Jet Boundary Condition Problem | mattyg101 | FLUENT | 7 | April 22, 2017 13:52 |
| Transient Simulation: Boundary Condition Problem | Shafiul | CFX | 7 | January 11, 2011 17:40 |
| problem about periodic boundary condition in Fluent | winnawinna | FLUENT | 0 | December 29, 2010 00:32 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
| boundary condition problem - NEED HELP | rave | Siemens | 2 | August 7, 2007 03:19 |
Linear Mode
