Abrasion modeling

omidiut · December 15, 2012, 05:46

Hi all
There is a plate with specified material such as aluminum. A high velocity and high temperature flow sprays on it. i'm trying to simulate abrasion of plate due to fluid flow.
Can i simulate it with CFX? How can i do it?
May i use two way FSI ?

Best regards,

ghorrocks · December 16, 2012, 05:14

Sure you can simulate it, but whether CFX can give you answers which are useful for you is another matter.

What are you trying to learn? What design problem are you looking into?

If you are interested in the fluid flow then CFX will work fine. If you are interested in erosion rates then CFX cannot help you much (but might be part of a simulation setup which can do this... maybe).

December 15, 2012, 05:46	Abrasion or erosion analysis	#1
omidiut Senior Member omid Join Date: Apr 2011 Posts: 105 Rep Power: 15	Hi all There is a plate with specified material such as aluminum. A high velocity and high temperature flow sprays on it. i'm trying to simulate abrasion of plate due to fluid flow. Can i simulate it with CFX? How can i do it? May i use two way FSI ? Best regards, Last edited by omidiut; December 15, 2012 at 08:08.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
May Focus Area: Turbulence Modeling	Jonas Larsson	CFD-Wiki	0	May 2, 2006 12:48
Modeling Flow/Saturation/Absorption in Fibers	Gene Dougherty	Main CFD Forum	0	June 6, 2003 15:49
Solid Modeling	Chris	Main CFD Forum	10	July 2, 2002 08:12
CFD Modeling of Two-phase Flow in Small Dia.Tubes	Eric Poindexter	Main CFD Forum	2	September 22, 2000 10:21
Extrusion Modeling	Elliot Schwartz	Main CFD Forum	1	September 11, 1998 20:08

December 16, 2012, 05:14		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,872 Rep Power: 144	Sure you can simulate it, but whether CFX can give you answers which are useful for you is another matter. What are you trying to learn? What design problem are you looking into? If you are interested in the fluid flow then CFX will work fine. If you are interested in erosion rates then CFX cannot help you much (but might be part of a simulation setup which can do this... maybe).