Remeshing with ICEM scripting

mileszczyns · December 10, 2012, 18:55

Hello,

Here is my problem. I'm trying to do simulation in CFX where considerably large displacements are taking place. Basically I'm moving a slider in a valve. I thought that it may be a good idea to use scripts in ICEM to make a meshing. I'd like to start with simulating 2.5D problem. I think that the best idea is to use hexa meshing via blocking function. So it's not a problem to make a blocking on this relatively simple geometry, but how to make another and automatic blocking using scripts in ICEM when solver face interruption condition ?

Secondly, I've tried to make a tetra meshing but geometry is replacing to the starting point during remeshing, even though the plot of the displacement is showing constant progress in one direction.

Thank you in advance.

mileszczyns · December 19, 2012, 20:33

I've found a solution to the replacing geometry problem while remeshing. It's important to use correct parameters when defining the time and displacement of the simulation.

December 10, 2012, 18:55	Remeshing with ICEM scripting	#1
mileszczyns New Member Join Date: Dec 2012 Posts: 5 Rep Power: 14	Hello, Here is my problem. I'm trying to do simulation in CFX where considerably large displacements are taking place. Basically I'm moving a slider in a valve. I thought that it may be a good idea to use scripts in ICEM to make a meshing. I'd like to start with simulating 2.5D problem. I think that the best idea is to use hexa meshing via blocking function. So it's not a problem to make a blocking on this relatively simple geometry, but how to make another and automatic blocking using scripts in ICEM when solver face interruption condition ? Secondly, I've tried to make a tetra meshing but geometry is replacing to the starting point during remeshing, even though the plot of the displacement is showing constant progress in one direction. Thank you in advance.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] ICEM Scripting Issues	tylerplowright	ANSYS Meshing & Geometry	33	September 27, 2021 17:35
remeshing using icem and cfx error	ajay_ks	CFX	1	April 21, 2014 17:37
[ICEM] Question about the use of ICEM tcl scripting	lnk	ANSYS Meshing & Geometry	9	January 16, 2013 10:24
ICEM CFD Replay Remeshing	EvaS	CFX	1	December 19, 2012 20:30
A problem of simulation using ICEM CFD Replay Remeshing	fluid vertical turbine	CFX	0	April 4, 2012 08:46

December 19, 2012, 20:33		#2
mileszczyns New Member Join Date: Dec 2012 Posts: 5 Rep Power: 14	I've found a solution to the replacing geometry problem while remeshing. It's important to use correct parameters when defining the time and displacement of the simulation.