[sjtusyc]

Details of error:-
----------------
Error detected by routine PSHDIR
CDRNAM = /FLOW/CONTROL/OUTPUT/TRNSTAT
CRESLT = NONE

Current Directory : /FLOW/SOLUTION/TSTEP2/CLOOP44/ZN1/BELG7/IP/TRNAVG

+--------------------------------------------------------------------+
| Writing crash recovery file |
+--------------------------------------------------------------------+

Details of error:-
----------------
Error detected by routine FNDFIL
CFNAME = *
CRESLT = OLD

Current Directory : /FLOW/SOLUTION/TSTEP2/CLOOP44/ZN1/VERTICES

+--------------------------------------------------------------------+
| An error has occurred in cfx5solve: |
| |
| The ANSYS CFX solver exited with return code 1. No results file |
| has been created. |
+--------------------------------------------------------------------+

End of solution stage.

+--------------------------------------------------------------------+
| The following transient and backup files written by the ANSYS CFX |
| solver have been saved in the directory I:\10Hz30Hz3\10Hz30Hz_001: |
| |
| 1_full.bak, 1.trn, 0.trn |
+--------------------------------------------------------------------+


+--------------------------------------------------------------------+
| An error has occurred in cfx5solve: |
| |
| Error reported by IO module: setfilebusyflag: more than one user |
| is reading I:\10Hz30Hz3\10Hz30Hz_001.dir\crash or the wrong lock |
| file I:\10Hz30Hz3\10Hz30Hz_001.dir\crash.lck exists |
+--------------------------------------------------------------------+


+--------------------------------------------------------------------+
| An error has occurred in cfx5solve: |
| |
| Error reported by IO module: iocnt: setfilebusyflag failed when |
| writing a data set |
+--------------------------------------------------------------------+


+--------------------------------------------------------------------+
| An error has occurred in cfx5solve: |
| |
| Error from IO module while writing G/MON:EVERY:1: |
| |
| "iocnt: setfilebusyflag failed when writing a data set" |
| |
| IO_LOCKED(21): File is locked. Remove the lock (lck) file if this |
| shouldn't be the case. |
+--------------------------------------------------------------------+


+--------------------------------------------------------------------+
| Warning! |
| |
| The ANSYS CFX Solver has written a crash recovery file. This file |
| has been saved as I:\10Hz30Hz3\10Hz30Hz_001.res.err and may be an |
| aid to diagnosing the problem or restarting the run. More details |
| should be available in the solver output section of the output |
| file. Note that a lock file was left for the crash file when the |
| solver exited, and so it is probably incomplete. |
+--------------------------------------------------------------------+


+--------------------------------------------------------------------+
| The following user files have been saved in the directory |
| I:\10Hz30Hz3\10Hz30Hz_001: |
| |
| solver.setup, mon |
+--------------------------------------------------------------------+


This run of the ANSYS CFX Solver has finished.

[ghorrocks]

The error is almost always with the first report. In this case it looks like the calculation of the transient average failed. Check it is set up correctly.