CFX solver error

sunilpatil · July 31, 2012, 07:49

Hello,
i am trying to simulate 3D model of fluid flow(velocity=2m/s) over a flat plate(thickness=5mm,length=100mm.width=100mm) while running in CFX solver i am getting following error

ERROR #001100279 has occurred in subroutine ErrAction. |
| Message: |
| Stopped in routine FPX: C_FPX_HANDLER |
| |
|
Help me to solve this problem

ghorrocks · July 31, 2012, 20:02

This is probably an overflow error:
http://www.cfd-online.com/Wiki/Ansys...do_about_it.3F

hamed.majeed · August 7, 2012, 13:35

Hi,

First you should check the mesh. Then the boundary conditions are very important. If you explain all that it would be helpful.
See this for flat plate help.
http://www.cfd-online.com/Forums/cfx...lysis-cfx.html

Would u mind telling me whether it is a random problem, or you are trying to validate some research paper.

Thank you

Regards
Hamed

July 31, 2012, 07:49	CFX solver error	#1
sunilpatil Senior Member sunil Join Date: Jul 2012 Location: Bangalore Posts: 179 Rep Power: 14	Hello, i am trying to simulate 3D model of fluid flow(velocity=2m/s) over a flat plate(thickness=5mm,length=100mm.width=100mm) while running in CFX solver i am getting following error ERROR #001100279 has occurred in subroutine ErrAction. \| \| Message: \| \| Stopped in routine FPX: C_FPX_HANDLER \| \| \| \| Help me to solve this problem

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
polynomial thermophysical properties II	sebastian	OpenFOAM Running, Solving & CFD	54	November 21, 2019 08:12
Problem running perturbUCyl	sen.1986	OpenFOAM	17	June 4, 2019 06:56
[swak4Foam] groovyBC: problems compiling: "flex: not found" and "undefined reference to ..."	sega	OpenFOAM Community Contributions	12	February 17, 2010 10:30
OpenFOAM on MinGW crosscompiler hosted on Linux	allenzhao	OpenFOAM Installation	127	January 30, 2009 20:08
Compiling problems with hello worldC	fw407	OpenFOAM Installation	21	January 6, 2008 18:38

July 31, 2012, 20:02		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,870 Rep Power: 144	This is probably an overflow error: http://www.cfd-online.com/Wiki/Ansys...do_about_it.3F

August 7, 2012, 13:35		#3
hamed.majeed Senior Member Hamed Abdul Majeed Join Date: May 2012 Location: New Orleans, LA, US Posts: 147 Rep Power: 14	Hi, First you should check the mesh. Then the boundary conditions are very important. If you explain all that it would be helpful. See this for flat plate help. http://www.cfd-online.com/Forums/cfx...lysis-cfx.html Would u mind telling me whether it is a random problem, or you are trying to validate some research paper. Thank you Regards Hamed