Plane in pre-cfx -- CFD Online Discussion Forums

June 12, 2012, 22:14	Plane in pre-cfx	#1
sepidecent New Member sepideh Join Date: Jul 2011 Posts: 21 Rep Power: 15	Hi All I have a geometry of rectangular box(450mm900mm225mm).There is a slot at the top of the box.For defining a slot first I put a plane(from surface),then the slot was drew.The slot was exactly at the middle of the box in my pre-cfx I extract the slot with imprint method,but when I look at post-cfx the slot has been move about 2-3 mm that make the results antisymmetric.I was wondering if anybody could help. Regards, SEpi

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Setting Pressure Boundary Conditions in ANSYS CFX Pre	saisanthoshm88	CFX	21	February 22, 2017 17:50
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 03:09
Under Relaxation Factors in CFX Pre	akj	Main CFD Forum	0	December 15, 2011 02:50
Locating the Monitor Points in CFX Pre	saisanthoshm88	CFX	2	November 30, 2011 10:58
Setting material properties - CFX Pre	cavani	CFX	6	January 27, 2011 20:52

All times are GMT -4. The time now is 22:17.