Transient Run - Output "Time" in partial results?

evcelica · May 16, 2012, 14:19

Greetings.

I am running a transient run and am outputting partial results as outputting everything would take up too much space. In the partial results, I choose my variables but I see "Time" is not one of them. Time is included by default if you stop the run and view all the partial results files in Post. But if I restart the run, or import those partial results files into CFD-Post using "add timesteps", then it has "0" for all the time values because it is not hard coded into the partial results files.
Is it possible to write "Time" in the partial results files, so I could import them into CFD-Post? Its not on the variables list and I can't type it in either.

Thanks in advance

ghorrocks · May 16, 2012, 19:55

Time is in the results files. Rather than adding timesteps if you load the final results file in CFD-Post then it will already know the time at each of the saved time steps.

evcelica · May 16, 2012, 22:36

Thanks for the reply.
I've never seen this option. Would It then be able to load several series from serial runs and have times for each one? How would I add the previous runs instead of using "add timesteps"?

May 16, 2012, 14:19	Transient Run - Output "Time" in partial results?	#1
evcelica Senior Member Erik Join Date: Feb 2011 Location: Earth (Land portion) Posts: 1,188 Rep Power: 23	Greetings. I am running a transient run and am outputting partial results as outputting everything would take up too much space. In the partial results, I choose my variables but I see "Time" is not one of them. Time is included by default if you stop the run and view all the partial results files in Post. But if I restart the run, or import those partial results files into CFD-Post using "add timesteps", then it has "0" for all the time values because it is not hard coded into the partial results files. Is it possible to write "Time" in the partial results files, so I could import them into CFD-Post? Its not on the variables list and I can't type it in either. Thanks in advance

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to map results from steady state run to tranient case?	phsieh2005	OpenFOAM Running, Solving & CFD	2	November 7, 2010 07:20
Error writing transient results in FSI	Pocket	CFX	1	April 15, 2010 07:57
Error reading transient results	Magnoli	CFX	3	March 4, 2010 09:29
Output transient file to csv	Ben	CFX	3	September 23, 2008 09:17
CFX-5.7 MPICH Parallel Problem (Output of Results)	James Date	CFX	7	February 15, 2005 17:03

May 16, 2012, 19:55		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,871 Rep Power: 144	Time is in the results files. Rather than adding timesteps if you load the final results file in CFD-Post then it will already know the time at each of the saved time steps.

May 16, 2012, 22:36		#3
evcelica Senior Member Erik Join Date: Feb 2011 Location: Earth (Land portion) Posts: 1,188 Rep Power: 23	Thanks for the reply. I've never seen this option. Would It then be able to load several series from serial runs and have times for each one? How would I add the previous runs instead of using "add timesteps"?