Reynolds number error - CFX

saisanthoshm88 · May 16, 2012, 06:26

I stopped a CFX run after 2262 iterations but I noticed the error " Reynolds number is out of range " when the run is stopped.

The reynolds number was reported to be low when the run started and I didn't see such error then but I found it to be higher after stopping the run.

I didn't even notice any intermittent errors (or) warnings when the run was going on.

Please find attached a pdf that shows the excerpts from the .out file.

Could some one please comment on this

ghorrocks · May 16, 2012, 07:09

This question has been asked thousands of times. DO a search on the forum for mre details.

In short, it is just a warning, not an error. If it is not applicable to you then ignore it.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Reynolds Number and Heat transfer Coefficient	panos_metal	FLUENT	0	January 7, 2011 07:37
DecomposePar unequal number of shared faces	maka	OpenFOAM Pre-Processing	6	August 12, 2010 10:01
Low Reynolds Number k-epsilon formulation CFX 10.0	Chris	CFX	4	December 8, 2009 00:51
Reynolds Number	Matt	CFX	0	February 25, 2009 06:40
[blockMesh] BlockMeshmergePatchPairs	hjasak	OpenFOAM Meshing & Mesh Conversion	11	August 15, 2008 08:36

May 16, 2012, 07:09		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,854 Rep Power: 144	This question has been asked thousands of times. DO a search on the forum for mre details. In short, it is just a warning, not an error. If it is not applicable to you then ignore it.