 |
 |
 |
|
|
|
[Sponsors] | ||||
CFX two-phase cyclic boundary condition problem |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 26, 2012, 13:58
|
CFX two-phase cyclic boundary condition problem
|
#1 |
|
New Member
Pang
Join Date: Jun 2010
Posts: 9
Rep Power: 16  |
Dear all,
does anyone have experience with two-phase flow simulation with cyclic boundary condition? I specified a total mass flow rate at the cyclic boundary. According to the CFX modeling help, the solver will correct the pressure drop, so the the specified mass flow rate will be established. However, the calculation I have run, which converged very good, shows that the total mass flow rate is considerably smaller than the originally specified value... I am quiet confused. Is the CFX solver (release 12.1 I am using) capable to do two-phase flow simulation with cyclic boundary condition? Any help will be appreciated! Thanks a lot in advance! Best regards, ukbid |
|
|
|
|
|
May 2, 2012, 05:09
|
|
#2 |
|
New Member
Pang
Join Date: Jun 2010
Posts: 9
Rep Power: 16 |
Just a update to this problem. I've contacted the CFX guys, it seems the solver is not capable to have cyclic boundary condition in multiphase flow simulation.
Best regards, ukbid |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UDS problem with wall boundary condition | Alex F. | FLUENT | 15 | September 21, 2015 10:28 |
| (Heattransfer) Temperature boundary condition problem | suitup | OpenFOAM Bugs | 15 | October 14, 2010 23:18 |
| Transient outlet boundary condition problem | jwillie2000 | CFX | 1 | December 7, 2009 18:07 |
| Periodic flow boundary condition problem | sudha | FLUENT | 3 | April 28, 2004 09:40 |
| a problem with Boundary condition | M Rad | Main CFD Forum | 12 | November 27, 1998 13:49 |
Linear Mode
