[DanielWoo]

Hi there,

Does any one know Tcl commands?

Recently I do a project related to the Tcl commands. According to the ICEM CFD Programmer's guide, I have done most work. But now I have a problem as follows:

ic_move_geometry surface names {SURF13 SURF12 SURF11 SURF9 SURF8 SURF7 CASING2.cut.1 CASING1 SURF2 HUB2.cut.1 WEB CASING2 HUB2 HUB1 TOP SURF6 SURF5 SURF4 SURF3 SURF1 SURF10} rotate 90 rotate_axis {0 1 0} cent {0 0 0}


I have run the above command in my procedures and it's OK. To make the command simple and clear, I replace "all" by the list of the names of the surfaces, but could not run it.

I'd appreciate if you guide me about this.