Pop the hood on ANSYS meshing
Posted October 4, 2012 at 14:05 by PSYMN
Thought I would show a little about how to "pop the hood" on ANSYS Meshing and Access the ICEM Technology underneath...
Here is a link...
http://www.ansys-blog.com/2012/10/04...ive/#more-3335
Here is a link...
http://www.ansys-blog.com/2012/10/04...ive/#more-3335
Total Comments 2
Comments
-
Thanks PSYMNPosted October 14, 2012 at 04:31 by Far
-
Hi Simon,
i need help to fix my errors in mesh, it has few uncovered surfaces due which my fluent is not proceeding. i am attaching the icem mesh. here is example for 1 mesh.
This is the Warning : Mesh has 24 uncovered faces.
Running FLUENT V6 Interface Vers. 14.0.3
Creating a Fluent 2D mesh.
Computing connectivity for 91080 cells.
Creating cell sections for 91080 cells.
Checking mesh:
interior faces : 181390
interior walls : 0
boundary faces : 1516
Warning : Mesh has 24 uncovered faces.
Creating face section for 182906 faces.
FLUENT V6 input file written
WARNING: Mesh has uncovered faces.
Done
WARNING: Mesh has uncovered edges. Fluent needs a complete boundary (lines in 2D) or it will give a variety of errors and not read in the mesh! If this was 2D Hexa, perhaps your edges are not associated with perimeter curves
Done with translation.
https://drive.google.com/file/d/0B_o...it?usp=sharing
regards
Sreedhar
sreeckg@gmail.comPosted December 1, 2013 at 10:13 by sreeckg
