Color by count...
Posted November 1, 2012 at 08:50 by kira
ICEM: explaining why you might see multiple curves in same location.
Quote:
Originally Posted by PSYMN
For the curves, turn on color by count... If you see yellow curves between two surfaces, then they are each single edge curves and you probably have two... Build topology will remove the duplicate if your tolerance is sufficient. This will also change the curve color by count to red, meaning a single curve is between those surfaces.
As for deleting curves, it really just makes them dormant. When you recreate a curve in the same location later, it first tries to restore the dormant curve. This has the effect of keeping your hopefully highest quality CAD curves. Not sure if that is what you are seeing, but I thought it was a good feature.
Good luck with ICEM CFD.
As for deleting curves, it really just makes them dormant. When you recreate a curve in the same location later, it first tries to restore the dormant curve. This has the effect of keeping your hopefully highest quality CAD curves. Not sure if that is what you are seeing, but I thought it was a good feature.
Good luck with ICEM CFD.
Total Comments 0
