printStack(Foam::Ostream& ) with simpleFoam -parallel
debug version will give line numbers. Ok. May worth the cost.
Quote:
A bit more information would be nice:
- does this problem also occur when you run the case in serial
- when does it happen (during the construction of the turbulence model, but I deduced that from your stack-trace)
- line numbers would be nice, but you'll need a Debug-version of OF for that
My guess is that this is (again) the old "I set k/epsilon/omega to 0 in the initial conditions (or on a boundary) and the turbulence model divides by it"-problem
Bernhard
- does this problem also occur when you run the case in serial
- when does it happen (during the construction of the turbulence model, but I deduced that from your stack-trace)
- line numbers would be nice, but you'll need a Debug-version of OF for that
My guess is that this is (again) the old "I set k/epsilon/omega to 0 in the initial conditions (or on a boundary) and the turbulence model divides by it"-problem
Bernhard
Total Comments 0