Generating Surface Stream Lines with Paraview (From 3D data)
Posted May 26, 2015 at 06:18 by Mehar
Being a Newbie, I have struggled to add surface streamlines to a slice, as I cannot find Appropriate instructions on this...However, after a long time struggle, I am able to add surface streamlines to a slice, which I would like to share with other newbies to avoid that head ace!
Following is the step by step procedure for generating surface streamlines!
1. Load Your Data in paraview
2. Add Slice filter to your Loaded Data
3. Add SurfaceVector filter to Slice
4. Add MaskPoint filter to SurfaceVector
5. Add StreamTracerWithCostumSource filter to SurfaceVector,a Dialogue Box will appear, select MaskPoint as Seed Source and Click Ok.
Wait for sometime, and Streamlines would be added to your Slice.
Note:
You Can Get Appropriate Streamlines by Playing With MaskPoints Setting "On Ratio", and "Maximum Number of Points"
Following is the step by step procedure for generating surface streamlines!
1. Load Your Data in paraview
2. Add Slice filter to your Loaded Data
3. Add SurfaceVector filter to Slice
4. Add MaskPoint filter to SurfaceVector
5. Add StreamTracerWithCostumSource filter to SurfaceVector,a Dialogue Box will appear, select MaskPoint as Seed Source and Click Ok.
Wait for sometime, and Streamlines would be added to your Slice.
Note:
You Can Get Appropriate Streamlines by Playing With MaskPoints Setting "On Ratio", and "Maximum Number of Points"
Total Comments 3
Comments
-
Thank you so much !!Posted April 4, 2017 at 04:40 by Ramsky
-
On Ratio is a good suggestion!Posted June 16, 2017 at 11:05 by random_ran
-
Thanks a lot.Posted March 26, 2019 at 01:27 by saket411
