Turbomachinery Setup -- CFD Online Discussion Forums

May 13, 2015, 12:57	Turbomachinery Setup	#1
techtradezone New Member Temidayo Join Date: Feb 2015 Posts: 7 Rep Power: 11	Hi, Please can anyone out there help me out on how to setup simulation on in-pipe turbine. i modeled a turbine to be inserted into the water pipelines, but when i simulate the model, the torque and the angular velocity are too small to be used for computation of power. power = torque * angular velocity. pls can i directly get power coefficient from the output parameters?, beside in setup i used free spinning for my rotating region while inertial was specified using autodesk CFD 2015. pls. can anyone help me

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Issues on the simulation of high-speed compressible flow within turbomachinery	dowlee	OpenFOAM Running, Solving & CFD	11	August 6, 2021 07:40
2D Glass Melt Simulation Setup	marmz	FLUENT	5	October 9, 2016 16:25
[ICEM] Hexa mesh, curve mesh setup, bunching law	Anorky	ANSYS Meshing & Geometry	4	November 12, 2014 01:27
General setup of turbomachinery cases	kornickel	OpenFOAM Pre-Processing	0	November 5, 2013 17:51
Recommended setup for cyclic turbomachinery computations	hani	OpenFOAM Running, Solving & CFD	5	January 25, 2006 04:11

All times are GMT -4. The time now is 13:51.