|
[Sponsors] |
December 12, 2012, 17:43 |
Help needed with moving parts
|
#1 |
New Member
Michael
Join Date: Dec 2012
Posts: 1
Rep Power: 0 |
Hi everyone!
I'd like to ask you to help me with proper setup of CFD simulation of moving parts. I'm new to CFD world and to Autodesk Simulation CFD. I have a part like the one attached. It rotates around shaft forced with water flow (it's some kind of turbine). Wing consists of two "flaps". They ought to be closed when water pushes wing and should open when it moves against water to reduce drag. I can setup angular motion for wing frame around shaft but I cannot properly setup flaps to rotate around theirs shafts AND move around with whole wing :/ I hope I described my problem quite well. Can somebody help me / guide me to properly setup the motion settings for this simulation? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help needed in modelling/meshing a body moving in a pipe which is driven by a fluid | hareshram.n | ANSYS | 1 | July 4, 2024 02:13 |
moving parts stress analysis | daniella | ANSYS | 0 | February 7, 2011 08:02 |
Confirmation Needed on fvMeshSubset and Moving Meshes | ngj | OpenFOAM Programming & Development | 1 | September 17, 2010 08:06 |
Moving parts | Anto | Siemens | 0 | September 17, 2008 10:18 |
Moving boundary tutorials needed by newbie! | Sebastián Arboleda | CFX | 0 | January 17, 2006 10:05 |