 |
 |
 |
|
|
|
[Sponsors] | ||||
August 18, 2011, 10:40
|
Setting your own residual equations
|
#1 |
|
New Member
Join Date: Aug 2011
Posts: 2
Rep Power: 0  |
Hello,
I am using Fluent 6.2.36 to model heat transfer and water transport through walls, and have got UDFs to model each phenomenon. Inside the UDFs are solvers that match boundary conditions on either side of the interface, and I was wondering if I could set some more solver equations that will make the programme iterate until my own residuals fall below a tolerance? Thank you, any help is appreciated. |
|
|
|
|
 |
| Tags |
| fluent 6.3.26, residuals, settings, udf |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| transsonic nozzle with rhoSimpleFoam | Unseen | OpenFOAM Running, Solving & CFD | 8 | July 1, 2022 07:54 |
| Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 12:08 |
| How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 16:33 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 06:24 |
| Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 12:16 |
Linear Mode
