Please, need help

happy · October 31, 2010, 05:12

Hello every member...

Acually, nowdays I have to simulate my 3D system by ANSYS 12 (CFX). However its mishing was not ready to run and get results So I have to create its own mesh to be able to have results. my issue is that I cannot get starting correctly. So I wait your support during next a few hours although I have already practised many tutorials to be perfect..my sys is opened vertical squer channel with slip beside each corner on each single wall and there is heat resource at its centre bottom.Please, could anyone ,please, help me and I will give him/her extra information.
In general, I need some general guidenece like which best code to draw my own mesh and so on

Kind regards.

happy · October 31, 2010, 18:52

Is there any member who would like to help me? It is first time I use ANSYS 12....please give me any ideas
In reality, I have already attemped to use workbench to make the mesh.
Thanks so much in advance

happy · November 1, 2010, 04:02

Hi everyone

I wait your replying... are u busy so much....Or you ignore me....Or

michael_owen · November 1, 2010, 10:05

At least post a picture of the geometry.

happy · November 2, 2010, 02:04

Hi micheal owen...

First of all, thanks for your replying and my system has has been done

regards

October 31, 2010, 05:12	Please, need help	#1
happy Senior Member Safia Join Date: Oct 2010 Location: Australia Posts: 161 Rep Power: 16	Hello every member... Acually, nowdays I have to simulate my 3D system by ANSYS 12 (CFX). However its mishing was not ready to run and get results So I have to create its own mesh to be able to have results. my issue is that I cannot get starting correctly. So I wait your support during next a few hours although I have already practised many tutorials to be perfect..my sys is opened vertical squer channel with slip beside each corner on each single wall and there is heat resource at its centre bottom.Please, could anyone ,please, help me and I will give him/her extra information. In general, I need some general guidenece like which best code to draw my own mesh and so on Kind regards.

November 2, 2010, 02:04	My information	#5
happy Senior Member Safia Join Date: Oct 2010 Location: Australia Posts: 161 Rep Power: 16	Hi micheal owen... First of all, thanks for your replying and my system has has been done regards Last edited by happy; November 4, 2010 at 10:50. Reason: no th.

October 31, 2010, 18:52		#2
happy Senior Member Safia Join Date: Oct 2010 Location: Australia Posts: 161 Rep Power: 16	Is there any member who would like to help me? It is first time I use ANSYS 12....please give me any ideas In reality, I have already attemped to use workbench to make the mesh. Thanks so much in advance

November 1, 2010, 04:02		#3
happy Senior Member Safia Join Date: Oct 2010 Location: Australia Posts: 161 Rep Power: 16	Hi everyone I wait your replying... are u busy so much....Or you ignore me....Or

November 1, 2010, 10:05		#4
michael_owen Senior Member Michael P. Owen Join Date: Mar 2009 Posts: 196 Rep Power: 17	At least post a picture of the geometry.