How to check the value of applied loads at keypoints ?

pathfinder_jj · December 11, 2009, 22:44

Hi all,

I have several sets of result after solving my analysis, I could access different sets of result by picking set "n" result from: Utility Menu > General Postproc > Read Results> By Pick.

however, when I tried to check each applied loads for each set of the result from: Main Menu > List > Loads > Forces > On All Keypoints, it only shows the applied loads for the last set of result.

Is there anyway that I could check the values for other sets of the result ?

Thank you.

rikio · January 5, 2010, 11:26

I am not sure about the detailed method, but I think this could be done through APDL to do a batch run, to get the wanted results of several files.

December 11, 2009, 22:44	How to check the value of applied loads at keypoints ?	#1
pathfinder_jj New Member Join Date: Dec 2009 Posts: 1 Rep Power: 0	Hi all, I have several sets of result after solving my analysis, I could access different sets of result by picking set "n" result from: Utility Menu > General Postproc > Read Results> By Pick. however, when I tried to check each applied loads for each set of the result from: Main Menu > List > Loads > Forces > On All Keypoints, it only shows the applied loads for the last set of result. Is there anyway that I could check the values for other sets of the result ? Thank you.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
OF 1.6 \| Ubuntu 9.10 (64bit) \| GLIBCXX_3.4.11 not found	piprus	OpenFOAM Installation	22	February 25, 2010 14:43
Problems in compiling paraview in Suse 10.3 platform	chiven	OpenFOAM Installation	3	December 1, 2009 08:21
Grid independence check	Mattis Voss	FLUENT	1	November 23, 2005 11:30
Cell check and Boundary check errors	AB	Siemens	4	October 28, 2004 14:04
3-D Mesh Check in Gambit.....	SHR	FLUENT	4	March 25, 2003 04:10

January 5, 2010, 11:26		#2
rikio Senior Member Rikio Join Date: Mar 2009 Location: SH, China Posts: 182 Blog Entries: 1 Rep Power: 17	I am not sure about the detailed method, but I think this could be done through APDL to do a batch run, to get the wanted results of several files.