Need help on Fluent

bawadi · August 12, 2009, 06:43

I have tried to run the stirred tank 2D model on fluent but when i want to start initializing, the error message appeared as below :

"WARNING: Unassigned interface zone detected for interface 4
Error: Init_Flow: unassigned interface_zones
Error Object: ()"

The "interface 4" was the interface between air and water.

Thank in advance for your help.

B. Abdullah

wadebogs · August 18, 2009, 16:13

Is the mesh conformal across this boundary?

It sounds like you don't understand what an interface is. In fluent "interface" refers to cases where you have meshed boundaries which are not conformal - the surfaces lie in the same place but nodes don't match.

If your nodes match you just need to change the boundary type to "interior".

Read the manual about grid interfaces.

August 12, 2009, 06:43	Need help on Fluent	#1
bawadi New Member bawadi Join Date: Jul 2009 Posts: 2 Rep Power: 0	I have tried to run the stirred tank 2D model on fluent but when i want to start initializing, the error message appeared as below : "WARNING: Unassigned interface zone detected for interface 4 Error: Init_Flow: unassigned interface_zones Error Object: ()" The "interface 4" was the interface between air and water. Thank in advance for your help. B. Abdullah

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Stopping a Fluent batch job AND saving the data! Possible?	Volker Pawlik	FLUENT	13	December 28, 2020 05:16
Two questions on Fluent UDF	Steven	Fluent UDF and Scheme Programming	7	March 23, 2018 04:22
Problems in lauching FLUENT	Lourival	FLUENT	3	January 16, 2008 17:48
FLUENT versions ...	Gautam	FLUENT	3	November 1, 2007 11:49
Run Fluent in batch mode	Shengping LUO	FLUENT	2	October 24, 2000 06:42

August 18, 2009, 16:13		#2
wadebogs New Member Join Date: Jul 2009 Posts: 16 Rep Power: 17	Is the mesh conformal across this boundary? It sounds like you don't understand what an interface is. In fluent "interface" refers to cases where you have meshed boundaries which are not conformal - the surfaces lie in the same place but nodes don't match. If your nodes match you just need to change the boundary type to "interior". Read the manual about grid interfaces.