Full Wing CFX Mesh Help

Slugg · May 17, 2009, 18:50

Hello,

I am relatively new to using CFX, and cannot seem to figure out how to get my wing model meshed. I modeled the wing in Inventor and cut it out of a box in Design Modeler for the boundary.

When trying to mesh the wing, I get a few errors: faces with small angles, small internal angles, boundary edge does not exit face, and no exit from face found.
For the first two, I usually can just create some virtual faces to fix the problems, but when I try to create a virtual face, it says the model contains calues that are invalid.
For the last two errors, I am not sure what the problem is or how to fix it.

http://smg.photobucket.com/albums/v2...=winginbox.jpg
http://smg.photobucket.com/albums/v2...winginbox2.jpg

I've been mostly referenceing the blunt body tutorial for setting this up, if that provides any more information.

I would greatly appreciate any help or advice.

amoolraina · June 2, 2010, 17:37

Hey did u manage to figure out a solution...if so do u mind sharing the same with me!..Please email me at amoolraina@hotmail.com ...Thanks

May 17, 2009, 18:50	Full Wing CFX Mesh Help	#1
Slugg New Member Mike Join Date: May 2009 Posts: 1 Rep Power: 0	Hello, I am relatively new to using CFX, and cannot seem to figure out how to get my wing model meshed. I modeled the wing in Inventor and cut it out of a box in Design Modeler for the boundary. When trying to mesh the wing, I get a few errors: faces with small angles, small internal angles, boundary edge does not exit face, and no exit from face found. For the first two, I usually can just create some virtual faces to fix the problems, but when I try to create a virtual face, it says the model contains calues that are invalid. For the last two errors, I am not sure what the problem is or how to fix it. http://smg.photobucket.com/albums/v2...=winginbox.jpg http://smg.photobucket.com/albums/v2...winginbox2.jpg I've been mostly referenceing the blunt body tutorial for setting this up, if that provides any more information. I would greatly appreciate any help or advice.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error when creating ICEM mesh output to CFX	Zoran	CFX	4	November 9, 2010 06:13
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55
CGNS mesh and CFX 10.0	tiziano	CFX	0	February 5, 2007 08:13
Mesh from ICEM CFD to CFX ! Error ! Why ? Thanks !	Vu Trinh Tuan	CFX	11	March 28, 2005 20:04
convert FLUENT mesh file to CFX mesh file??	frederic felten	FLUENT	5	December 6, 1999 10:32

June 2, 2010, 17:37		#2
amoolraina New Member Amool A Raina Join Date: May 2010 Posts: 14 Rep Power: 16	Hey did u manage to figure out a solution...if so do u mind sharing the same with me!..Please email me at amoolraina@hotmail.com ...Thanks