setting of geometry -- CFD Online Discussion Forums

August 12, 2024, 18:22

setting of geometry

maryamkiaee

New Member

maryam kia

Join Date: Aug 2024

Posts: 1

Rep Power: 0

hello everyone

I have drawn this geometry several times, and when I combine the building with the wind tunnel, it closes the bottom of the building.

If I delete that part, solid becomes surface, which I think is not correct.

I don't know what to do?

Of course, I took this into icem and mashed it. There was no problem until then, but inside fluent does not show the building.

Attached Images

1.jpg (116.2 KB, 6 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] CATIA Geometry Generation and Meshing	danielsullivan	ANSYS Meshing & Geometry	0	April 3, 2017 22:11
Setting up Turbomachinery Geometry	supermgm	STAR-CCM+	4	November 20, 2016 14:38
Problem setting the interfaces of a geometry	Maralady	FLUENT	1	August 8, 2013 20:20
Problem Importing Geometry ProE to CFX	fatb0y	CFX	3	January 14, 2012 20:42
Cells with t below lower limit	Purushothama	Siemens	2	May 31, 2010 22:58

All times are GMT -4. The time now is 13:42.