|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Ran soffer
Join Date: May 2024
Posts: 3
Rep Power: 2 ![]() |
I have a wavy tunnel, and I want to process the data, but if I use ASCII, I need to interpolate the data in Matlab, and that pain is in the #$@. i need a lot of velocity plots and Nu data at each x so I can't proses most of it in fluent; how can I get data or preprocess like MATLAB to get matrixes to something like that? or even interpolation the data to a very structured mash then transfer the data to a matrix or anything like that
|
|
![]() |
![]() |
![]() |
Tags |
fluent 14 to fluent 15. |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to run fluent from matlab without using aas toolbox? | artemis96 | ANSYS | 7 | May 23, 2022 12:16 |
[OpenFOAM] How to get the coordinates of velocity data at all cells and at all times | vidyadhar | ParaView | 9 | May 20, 2020 20:06 |
Running UDF with Supercomputer | roi247 | FLUENT | 4 | October 15, 2015 13:41 |
OpenFoam to Fluent data conversion Problem | vemps | OpenFOAM | 1 | August 8, 2011 02:30 |
Data import in Fluent?! | Bart Horsten | FLUENT | 3 | February 22, 2010 13:05 |