 |
 |
 |
|
|
|
[Sponsors] | ||||
Importing a Slotted Airfoil into Ansys, however error appears when creating 3D curve |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 28, 2024, 00:29
|
Importing a Slotted Airfoil into Ansys, however error appears when creating 3D curve
|
#1 |
|
New Member
ale
Join Date: Jan 2023
Posts: 2
Rep Power: 0  |
Hello,
I am trying to run some tests on a S103, a slotted airfoil. This airfoil essentially has two elements, and I was thinking I should import each one individually and figure out the rest in Ansys. However, When I go to import the first part of the airfoil into ANSYS through a 3D curve, it gives me "Error reading Coordinates File". I have looked in the forum and tried the existing solutions but have failed in solving this issue. The file is attached. If you have any questions please let me know. Any help would be appreciated. |
|
|
|
|
|
March 1, 2024, 11:03
|
Solution
|
#2 |
|
New Member
ale
Join Date: Jan 2023
Posts: 2
Rep Power: 0 |
Ignore this, I for some reason forgot Fusion 360 existed so I just modeled the airfoil in there and imported into Ansys.
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] gmshToFoam generates patches with 0 faces and 0 points | Simurgh | OpenFOAM Meshing & Mesh Conversion | 4 | August 25, 2023 08:58 |
| [DesignModeler] Error at loading airfoil coordinates into ANSYS DesignModeler | mix | ANSYS Meshing & Geometry | 4 | October 12, 2014 08:02 |
| [ICEM] Importing cambered airfoil geometry to ICEM CFD | kotimari | ANSYS Meshing & Geometry | 2 | July 16, 2012 16:44 |
| Creating inflation layers for elbow with airfoil ! | Aplus | CFX | 1 | March 13, 2006 23:22 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 13, 2001 00:19 |
Linear Mode
