 |
 |
 |
|
|
|
[Sponsors] | ||||
unable to update output parameters in Parametric Study |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 2, 2023, 01:37
|
unable to update output parameters in Parametric Study
|
#1 |
|
New Member
Vaibhav Hiwale
Join Date: Dec 2021
Location: India
Posts: 3
Rep Power: 4  |
Hello,
I have parametrized my fluent setup in ansys workbench and run 10 iterations each on the host computer. Now im running those generated cases and data files on multiple nodes on HPC simultaneously. After convergence, I copy them along with reports to their folders on the host computer. But the output parameters value is not updating in the table of design points tab for the converged solution. Kindly give a solution for this problem. |
|
|
|
|
|
| Tags |
| design points, optimizaion, parametric analysis |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] outputTime in Swak function | immortality | OpenFOAM Community Contributions | 20 | October 6, 2022 13:08 |
| Solver parameters to solve convergence issue | WilliamH | SU2 | 5 | February 5, 2021 07:19 |
| Parametric Study - Multiple Configurations in ANSYS CFX | kskong | CFX | 1 | June 7, 2016 09:22 |
| Changing Workbench Output Parameters - Update without re-solving? | murx | CFX | 3 | June 5, 2013 10:46 |
| Parametric Study | Murat | FloEFD, FloWorks & FloTHERM | 1 | October 13, 2008 04:20 |
Linear Mode
