 |
 |
 |
|
|
|
[Sponsors] | ||||
September 2, 2022, 03:35
|
Parameterization in Fluent
|
#1 |
|
New Member
Johny_walker
Join Date: Feb 2020
Posts: 17
Rep Power: 6  |
Hello all,
I have created a 2D parameterized geometry in NX and have imported into Ansys Fluent through design modeler. All the parameters have also been imported and I have created the mesh and setup the simulation. When I click on update all design points, I get this error for all the design points: (DP (number)) Update of the Mesh component in Fluid Flow (Fluent) for Design Point (number) failed: Unable to attach to geometry file. Unable to attach geometry. Can anyone tell the reason for this error? |
|
|
|
|
 |
| Tags |
| ansys, cfd, design points, fluent |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CFX vs. FLUENT | turbo | CFX | 4 | April 13, 2021 09:08 |
| How to solve UDF compilation problems in Fluent. | pakk | Fluent UDF and Scheme Programming | 16 | September 10, 2018 03:48 |
| Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 04:22 |
| heat transfer with RANS wall function, over a flat plate (validation with fluent) | bruce | OpenFOAM Running, Solving & CFD | 6 | January 20, 2017 07:22 |
| Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 17:48 |
Linear Mode
