|
[Sponsors] |
[ICEM] Negative determinant 3x3x3 while meshing propeller blade |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Thomas
Join Date: Nov 2021
Posts: 2
Rep Power: 0 ![]() |
Dear all,
I have been trying to mesh the propeller blade with periodic boundaries in ICEM. The problems are that I get around 6k elements with negative Determinant 3x3x3, and 1k of elements with angles lower than 9 deg, as the figures showed. To fix those issues, I only know we can edit the edge and split it with the "spline" or "control point" method to increase the angle. I wonder if someone can tell me how to improve Determinant 3x3x3. Thomas DET.jpg ANG.jpg |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
[blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 05:42 |
Negative determinant in a multiblock o-mesh | Cosimo | Mesh Generation & Pre-Processing | 4 | March 19, 2013 08:42 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
360 degree fluid zone for a 4 blade propeller | s0me0ne | CFX | 5 | June 27, 2010 07:09 |