Missing Tets along trailing edge

ys1998 · March 23, 2021, 23:29

Hello everyone. I am new to ICEM CFD and I've been trying to create a 3D mesh on an ONERA M6 wing.
But whatever I have tried, I can't seem to get rid of the missing elements along the trailing edge.
Does anyone know why this is happening and what I can do to solve this? I've attached an image showing the problematic area. Thanks in advance.

Gert-Jan · March 26, 2021, 08:45

1) ask this question in the Meshing/Geometry section. Not here.
2) look in the help. Go to:
ICEM CFD ->Help Manual -> Mesh -> Global Mesh Setup -> Volume Mesh Parameters -> Tetra/Mixed -> Robust (Octree)

There your problem is clarified

ys1998 · March 26, 2021, 10:34

Sorry. I'm new to the forum. Will do. Thank you!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
Trailing edge sensitivity anlaysis	JanH	SU2	2	November 23, 2018 14:53
[ICEM] Hole near sharp trailing edge of airplane/wing geometry	jlichtwa	ANSYS Meshing & Geometry	2	September 21, 2010 16:19
Which trailing edge is correct for meshing of aerofoils for CFX	LSC	CFX	0	May 10, 2009 13:45
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55

March 26, 2021, 08:45		#2
Gert-Jan Senior Member Gert-Jan Join Date: Oct 2012 Location: Europe Posts: 1,928 Rep Power: 28	1) ask this question in the Meshing/Geometry section. Not here. 2) look in the help. Go to: ICEM CFD ->Help Manual -> Mesh -> Global Mesh Setup -> Volume Mesh Parameters -> Tetra/Mixed -> Robust (Octree) There your problem is clarified

March 26, 2021, 10:34		#3
ys1998 New Member S YASHWANTH Join Date: Jul 2020 Location: Bangalore Posts: 2 Rep Power: 0	Sorry. I'm new to the forum. Will do. Thank you!