Home > Forums > Software User Forums > ANSYS

Mesh adaption with inflated mesh boundaries

Updated Threads

Reply

Search this Thread

March 15, 2021, 22:55	Mesh adaption with inflated mesh boundaries	#1
Mwbadawy New Member Mohamed Wael Join Date: Oct 2019 Posts: 6 Rep Power: 7	Hi.. I am simulating the motion of a droplet in a micro-channel where the droplet dynamics is highly dependent on the thin layer of fluid between the interface and the wall boundaries. I am trying to use VOF mesh adaption while i am using inflated mesh near the boundaries. However, I am always facing the problem of having a layer of non-adapted mesh between the inflated layers and the adapted zone. I have tried to separate the inflated mesh zone and retry the mesh adaption but i got the same results. I would like to know if there is a method that can successfully adapt the mesh according to the VOF in the vicinity of the inflated mesh zone. E5CCBF78-F5E3-4435-A9F3-CA4DBAEB4B5E.jpg

Reply

Tags

droplet, inflation, mesh adaption, vof

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] non uniform mesh near the stl object	vava10	OpenFOAM Meshing & Mesh Conversion	0	January 31, 2021 15:41
[snappyHexMesh] Creating multiple multiple cell zones with snappyHexMesh - a newbie in deep water!	divergence	OpenFOAM Meshing & Mesh Conversion	0	January 23, 2019 05:17
Mesh motion with Translation & Rotation	Doginal	CFX	2	January 12, 2014 07:21
[snappyHexMesh] Layers:problem with curvature	giulio.topazio	OpenFOAM Meshing & Mesh Conversion	10	August 22, 2012 10:03
Unstructured Mesh using Mesh adaption	sidzishere	CFX	1	May 31, 2011 11:18

All times are GMT -4. The time now is 14:00.