 |
 |
 |
|
|
|
[Sponsors] | ||||
Help with 2d mesh with complex curve (fluent) |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 29, 2021, 15:40
|
Help with 2d mesh with complex curve (fluent)
|
#1 |
|
New Member
Lucas Lima
Join Date: Jan 2021
Posts: 2
Rep Power: 0  |
Good morning CFD online, i've been trying to simulate the performance of a rocket combustion chamber+nozzle, but unfortunely the simulation always tend to make the resiuduals jump after (90-500itr), so i assume this is due to the mesh quality, since the nothing seems to fix it.
im almost sure this instabilities derive from a certain spot on the mesh, more precisely where the converging part of the nozzle starts: https://www.cfd-online.com/Forums/at...1&d=1611949127 i cannot find any information on how to reduce this section's skewness. Looking forward to fix this issue ! |
|
|
|
|
|
| Tags |
| 2d., mesh and fluent, mesh angle, skewed cells |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OpenFOAM error | Vinay Kumar V | Main CFD Forum | 0 | February 20, 2020 10:17 |
| FLUENT adding mesh nodes problem when importing 3D mesh from ICEM | guxin7005 | FLUENT | 2 | June 27, 2016 22:41 |
| Lift and Drag pattern change wit FLUENT 16 and 13 PISO for same mesh n solver setting | arunraj | FLUENT | 0 | June 2, 2016 23:58 |
| [Other] Pointwise Mesh into Fluent - Error: "Divergence detected in AMG solver: ads-0." | kyles.sverige | ANSYS Meshing & Geometry | 3 | January 27, 2015 13:28 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
Linear Mode
