Export Point Method in Blade gen toolbar in Design Modeler -- CFD Online Discussion Forums

November 4, 2020, 04:11	Export Point Method in Blade gen toolbar in Design Modeler	#1
Ajmit New Member AJMIT KUMAR Join Date: Jul 2020 Location: India Posts: 5 Rep Power: 6	What is Hub/Shroud offset present in Export Point technique? Does it cut/trim down the blade profile while exporting to Turbogrid?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
JScript for Start Over - Design Modeler	Tim Crimson	Fluent UDF and Scheme Programming	0	January 28, 2020 07:35
[BladeModeler] How to export fluid zone of a blade from DM ?	shivasluzz	ANSYS Meshing & Geometry	0	October 6, 2016 10:16
OpenFOAM on MinGW crosscompiler hosted on Linux	allenzhao	OpenFOAM Installation	127	January 30, 2009 20:08
Design Modeler to ICEM.....	Joe	CFX	0	January 24, 2008 04:39
[Gmsh] Gmsh and samplesurface	touf	OpenFOAM Meshing & Mesh Conversion	2	December 10, 2007 03:27

All times are GMT -4. The time now is 13:51.