 |
 |
 |
|
|
|
[Sponsors] | ||||
September 28, 2020, 04:48
|
Ansys AUTODYN
|
#1 |
|
Member
|
Hello,
I was trying to model explosion and obtained P(t) curve via Gauge point. Now, I would like to get impulse result for that P(t) curve. In the History menu when you make P(t) curve there is an option INTEGRATE bellow. I guess it is here for impulse calculation, but I usually get bad results. How to get accurate reading of impulse for particular P(t) curve since when I do INTEGRATE, I get another curve? Here are the curves: https://ibb.co/CzdnGsK https://ibb.co/CWyRNnY
__________________
I'M NOT A GYNECOLOGIST BUT I'LL TAKE A LOOK. |
|
|
|
|
 |
| Tags |
| autodyn ansys |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Running Ansys in BAtch Mode | kuleuvenstudent | ANSYS | 1 | October 18, 2017 13:11 |
| Ansys HPC licensing policy | assafwei | ANSYS | 0 | June 29, 2014 17:00 |
| Using ICEM CFD to repair/edit ANSYS Meshing | Kaaji1359 | ANSYS | 2 | July 30, 2013 11:28 |
| ANSYS AUTODYN 3D simulation | ATD | ANSYS | 0 | December 13, 2012 04:25 |
| Exporting results from CFX to ANSYS ?? | sohail ahmed | CFX | 1 | December 20, 2007 02:10 |
Linear Mode
