Unable to start geometry editor - Centos7

xmatheuz · August 28, 2019, 09:29

Hi Everybody,
I researched a lot of forums to solve this problem. But they don't help me.
Ansys licences are works very well. Workbench is opened normally.
But when i create the fluent environment and i try to open the Geometry editor the following error pop-up: Unable to start the geometry editor.

Please help

System: centos7
Ansys version: 19.0

piprus · July 26, 2021, 06:31

I know it passed some time since the post showed up, but I found the same problem just now. I have exactly the same setup as you specified (OS and ANSYS WB version). I use a workflow made of 3 blocks, i.e. geometry, mesh and Fluent... What I found is that only geometry and mesh don't run while Fluent starts and proceed smoothly. Another interesting fact is that all these worked well till the Febrary/March this year. Since I haven't use it (geometry or mesh) for some time so I haven't realized the problem exists. If someone knows some solution or find similar problem would be nice to know.

Regards,
Piotr

August 28, 2019, 09:29	Unable to start geometry editor - Centos7	#1
xmatheuz New Member br_ Join Date: Mar 2016 Posts: 1 Rep Power: 0	Hi Everybody, I researched a lot of forums to solve this problem. But they don't help me. Ansys licences are works very well. Workbench is opened normally. But when i create the fluent environment and i try to open the Geometry editor the following error pop-up: Unable to start the geometry editor. Please help System: centos7 Ansys version: 19.0

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[CAD formats] Unable to import STL properly to create final geometry	miguel.delasheras	OpenFOAM Meshing & Mesh Conversion	2	January 27, 2019 07:27
[DesignModeler] Unable to Import Geometry	Alan212	ANSYS Meshing & Geometry	3	March 17, 2015 12:26
[ANSYS Meshing] How to start meshing this geometry?	Thomashoffmann	ANSYS Meshing & Geometry	4	March 16, 2013 00:23
Problem in running ICEM grid in Openfoam	Tarak	OpenFOAM	6	September 9, 2011 18:51
Unable to start fluent in parallel mode	Anand	FLUENT	1	January 11, 2009 17:48

July 26, 2021, 06:31		#2
piprus Member Piotr Prusinski Join Date: Oct 2009 Location: Warsaw, Poland Posts: 67 Rep Power: 17	I know it passed some time since the post showed up, but I found the same problem just now. I have exactly the same setup as you specified (OS and ANSYS WB version). I use a workflow made of 3 blocks, i.e. geometry, mesh and Fluent... What I found is that only geometry and mesh don't run while Fluent starts and proceed smoothly. Another interesting fact is that all these worked well till the Febrary/March this year. Since I haven't use it (geometry or mesh) for some time so I haven't realized the problem exists. If someone knows some solution or find similar problem would be nice to know. Regards, Piotr