 |
 |
 |
|
|
|
[Sponsors] | ||||
March 21, 2019, 05:50
|
Connections in Workbench mesher
|
#1 |
|
New Member
crinoid
Join Date: Jan 2019
Posts: 22
Rep Power: 7  |
Hi,
I'm trying to mesh a heat exchanger where I have 3 zones: water, pipes and air... When I import the geometry to the Workbench mesher I see that there are 3 connections: water-pipe (ok), pipe-air (ok) and water-air (that's wrong). I've checked the geometry and I see no physical conection between those 2 zones so, how could that be? Thanks in advance! |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Workbench 18.2 Installation Error Ubuntu 16.04 | turbostudent | ANSYS | 1 | October 3, 2019 11:13 |
| FLUENT installation on UBUNTU 12.04 (LTS) | teymourj | FLUENT | 2 | March 1, 2017 23:24 |
| [ANSYS Meshing] trying to mesh a saloon car in wind-tunnel with Ansys 13.0 Workbench mesher | IvanCFD | ANSYS Meshing & Geometry | 10 | July 8, 2014 16:55 |
| [ANSYS Meshing] import mesh to Workbench mesher | la7low | ANSYS Meshing & Geometry | 11 | October 23, 2013 16:56 |
| Ansys Workbench Mesher creating Wall instead of Interior | Tech Neo | ANSYS | 2 | March 26, 2012 00:27 |
Linear Mode
