Ported Shroud

marsa27 · May 22, 2018, 10:55

Hello, i would like to ask a question about turbogrid. I want to create a ported shroud centrifugal impeller. So, my question is if it's possible to split shroud surface in smaller parts in order to connect one with the port via Frozen rotor. Is there any different way? Thank you

t8fanning · January 29, 2020, 11:42

Did you ever have any success with this? I'm trying to do the same. I've split the shroud face in Design Modeler, but that split does not carry over into Turbogrid.

marsa27 · January 29, 2020, 11:47

Quote:

Originally Posted by t8fanning

Did you ever have any success with this? I'm trying to do the same. I've split the shroud face in Design Modeler, but that split does not carry over into Turbogrid.

Yes, my solution was been to import the mesh as .CGNS from Turbogrid to Icem and here manually add some faces meshes in a new part.

t8fanning · January 29, 2020, 12:38

Good idea. Unfortunately I don't have an ICEM license. I do have meshing in Workbench, but it doesn't seem like you can modify an imported mesh. I'll have to try and figure something else out.

May 22, 2018, 10:55	Ported Shroud	#1
marsa27 Senior Member Davide Join Date: Jul 2015 Posts: 107 Rep Power: 11	Hello, i would like to ask a question about turbogrid. I want to create a ported shroud centrifugal impeller. So, my question is if it's possible to split shroud surface in smaller parts in order to connect one with the port via Frozen rotor. Is there any different way? Thank you

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ported shroud Centrifugal Compressor Ansys Turbogrid	rusty0632	ANSYS	0	April 3, 2018 05:09
Ported Shroud in CFX	vitulaaak	CFX	1	April 3, 2018 04:31
[BladeModeler] How to set the shroud diameter in Blade Generator	Stabum	ANSYS Meshing & Geometry	1	January 17, 2018 15:22
Define Hub and Shroud for imported CAD file	Daniel DA	Fidelity CFD	7	May 18, 2016 09:03
compressor shroud clearance	Selina_stj	ANSYS	9	May 20, 2011 14:06

January 29, 2020, 11:42		#2
t8fanning Member Tate Join Date: Feb 2015 Posts: 31 Rep Power: 11	Did you ever have any success with this? I'm trying to do the same. I've split the shroud face in Design Modeler, but that split does not carry over into Turbogrid.

January 29, 2020, 12:38		#4
t8fanning Member Tate Join Date: Feb 2015 Posts: 31 Rep Power: 11	Good idea. Unfortunately I don't have an ICEM license. I do have meshing in Workbench, but it doesn't seem like you can modify an imported mesh. I'll have to try and figure something else out.