Problem with meshing model

abcek · November 14, 2017, 13:13

Hi, I have a problem with meshing basic model.

I would like meshing model with size 1mm, but one face I would like meshing with size 0,01 mm. I choose sizing one face and 0,01. Then, generate mesh but all of them is meshing with this size. Could You help me?

Best regards

LK_1000 · November 15, 2017, 12:29

Please share picture of your model and mesh settings.

sultzan · November 19, 2017, 09:43

You could possibly solve this issue by changing beviour of the mesh properties. Simply click on the sizing cell (the one with 0.01 mm size) and in the details -> advanced change behaviour from "soft" to "hard". Do not change it for the 1mm size since both of these conditions will be probably impossible to fulfill. Hope it helps.

November 14, 2017, 13:13	Problem with meshing model	#1
abcek New Member Adal Join Date: Nov 2017 Posts: 1 Rep Power: 0	Hi, I have a problem with meshing basic model. I would like meshing model with size 1mm, but one face I would like meshing with size 0,01 mm. I choose sizing one face and 0,01. Then, generate mesh but all of them is meshing with this size. Could You help me? Best regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Superlinear speedup in OpenFOAM 13	msrinath80	OpenFOAM Running, Solving & CFD	18	March 3, 2015 06:36
problem in glass radiation model (DO model)	wunan805	FLUENT	0	October 10, 2012 06:06
Mixture model problem - could someone please advise?	matlab_monkey	FLUENT	2	July 26, 2012 09:20
Problem importing watertight model into CFX	djk1301	ANSYS	3	February 1, 2011 23:04
[GAMBIT] Desperate student needs help meshing 3D GAMBIT model - please help!	lau06165	ANSYS Meshing & Geometry	1	March 22, 2010 02:09

November 15, 2017, 12:29		#2
LK_1000 New Member LK_ Join Date: Oct 2017 Posts: 16 Rep Power: 9	Please share picture of your model and mesh settings.

November 19, 2017, 09:43		#3
sultzan New Member Join Date: Oct 2017 Posts: 20 Rep Power: 9	You could possibly solve this issue by changing beviour of the mesh properties. Simply click on the sizing cell (the one with 0.01 mm size) and in the details -> advanced change behaviour from "soft" to "hard". Do not change it for the 1mm size since both of these conditions will be probably impossible to fulfill. Hope it helps.