 |
 |
 |
|
|
|
[Sponsors] | ||||
November 6, 2017, 05:30
|
Regarding Inflation
|
#1 |
|
New Member
RAM
Join Date: Nov 2017
Posts: 4
Rep Power: 9  |
Hi
Pre-inflation layer generation has stopped because of side face limitation, proximity collisions and quality. Can anyone tell me why i am getting this error My geometry has tubes with thickness |
|
|
|
|
|
May 5, 2020, 15:12
|
|
#2 |
|
New Member
Rayza Vicente
Join Date: May 2020
Posts: 1
Rep Power: 0 |
Hi, did you solve the problem? I have the same issue, am studying small thickness tubes.
|
|
|
|
|
|
|
May 5, 2020, 17:14
|
|
#3 |
|
Senior Member
Gert-Jan
Join Date: Oct 2012
Location: Europe
Posts: 1,928
Rep Power: 28 |
Use the Post-inflation algorithm.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Boundary Layer - Inflation Layer | dlkadk | FLUENT | 0 | September 16, 2017 12:11 |
| [ANSYS Meshing] 3D Inflation mesh on an airfoil | kennyboy | ANSYS Meshing & Geometry | 1 | April 26, 2017 04:12 |
| [ANSYS Meshing] Inflation Layers Being Finicky | Markua | ANSYS Meshing & Geometry | 12 | April 28, 2015 08:11 |
| Fluent diverges when using inflation layers | ziggo | FLUENT | 4 | August 9, 2013 13:11 |
| Inflation | Gab | CFX | 6 | August 24, 2005 23:45 |
Linear Mode
