 |
 |
 |
|
|
|
[Sponsors] | ||||
August 28, 2017, 11:46
|
Unit's problem with Finite Element Modeler
|
#1 |
|
New Member
Carlos Modesto
Join Date: Feb 2017
Posts: 7
Rep Power: 9  |
Hello Everyone!
I have an issue regarding FE Modeler; I created a mesh on icem and then use FEM to change the type to the one accepted by transient stuctural, but when the transformation is performed the size of the mesh is reduced, it passed from 1 m to 1 mm does somebody knows how to correct this?. Thanks in advance |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mass conservation problem, Finite Element | iahmedimtiaz | System Analysis | 0 | September 19, 2015 21:09 |
| link between finite element modeler and ansys structural | mortazavi | Mesh Generation & Pre-Processing | 0 | July 17, 2015 17:26 |
| Two way Fsi Problem- Non linear problem | kmgraju | CFX | 4 | April 28, 2015 12:15 |
| Finite Element vs. Finite Volume Codes | Salman | Main CFD Forum | 9 | January 6, 2006 23:59 |
| finite element vs. finite difference | Zoltan Turzo | Main CFD Forum | 2 | February 20, 1999 08:42 |
Linear Mode
