Spirally Fluted Pipe -- CFD Online Discussion Forums

August 1, 2017, 17:22	Spirally Fluted Pipe	#1
arehman1289 New Member Abdul Join Date: Aug 2017 Posts: 27 Rep Power: 9	I am trying to make a spirally fluted pipe in ANSYS. I made the cross section as in the attached figure and sweeped on a straight line perpendicular to plane of the cross section. However I get a sort of a drill bit instead of the required spirally fluted pipe. Is there an issue with the cross section or the way I sweep ? Thank you very much in advance 18870865_10155077565896253_1621426967_n.jpg 18836287_10155077566996253_707314310_o.jpg

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[DesignModeler] DesignModeler Pipe within pipe	shields	ANSYS Meshing & Geometry	13	November 25, 2018 23:14
Double Walled Pipe Boundary	dahvqaz	FLUENT	2	December 5, 2012 11:14
My Revised "Time Vs Energy" Article For Review	Abhi	Main CFD Forum	2	July 9, 2002 10:08
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 10:11
fluid flow fundas	ram	Main CFD Forum	5	June 17, 2000 22:31

All times are GMT -4. The time now is 22:49.