Problem with mesh microchannel simmulation in Ansys Fluent -- CFD Online Discussion Forums

November 30, 2016, 02:24

Problem with mesh microchannel simmulation in Ansys Fluent

anjas_HK

New Member

Anjas Adi Gumilang

Join Date: Nov 2016

Posts: 1

Rep Power: 0

Hello all,

I have some problems when did some simulation in microchannel heat sink. from the reference I got, it said "A mesh with 50 × 100 × 50
(base × height × length of the channel) elements with a refinement ratio of 1.2 near the walls was identified as the suitable density
for grid-independent results". I don't understand with "mesh with 50 x 100 x 50 elements", could anyone explain to me about this?
I only did normal meshing with body sizing before, but i didn't get results that i wanted.

Attached Files

Murray - 60 deg - 4 bifurcation (3).zip (19.4 KB, 11 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem in temperature distribution in Ansys Fluent	ALI Riaz	FLUENT	0	March 6, 2016 14:05
[ICEM] ICEM CFD Problem with the boundary conditions while importing the mesh to fluent	sonic109	ANSYS Meshing & Geometry	2	September 3, 2014 01:56
Interesting problem: Parallel Processor VOF Fluent + Dynamic Mesh + System Coupling	spaceprop	FLUENT	5	September 2, 2014 10:43
The fluent stopped and errors with "Emergency: received SIGHUP signal"	yuyuxuan	FLUENT	0	December 3, 2013 23:56
Ansys mesh for FLUENT software giving unrealistic results, while GAMBIT mesh is fine	kbhamidipa3	FLUENT	0	November 30, 2012 16:52

All times are GMT -4. The time now is 23:24.