SpaceClaim enclosure around surface model (baffles)

jackkra · November 1, 2016, 05:50

Hi!
I can't find how to make an enclosure around an surface model in SpaceClaim. The model is made from surfaces and is supposed to be meshed with ansys and later on transferd to OpenFOAM using fluent3DMeshToFoam.

The "enclousre" in SpaceClaim does work perfectly using solids, but this model consists only of zero thickness surfaces (baffles) and it doesnt work at all.

Have anyone else experiensed this problem?

//jackkra

Tscar · December 10, 2016, 04:34

Hi,

I have the same problem right now. Did you find a solution?

Thanks.

jackkra · December 20, 2016, 08:14

I haven't found any solution to this issue yet. Anyone else? Tscar?

November 1, 2016, 05:50	SpaceClaim enclosure around surface model (baffles)	#1
jackkra New Member Join Date: Sep 2016 Posts: 4 Rep Power: 10	Hi! I can't find how to make an enclosure around an surface model in SpaceClaim. The model is made from surfaces and is supposed to be meshed with ansys and later on transferd to OpenFOAM using fluent3DMeshToFoam. The "enclousre" in SpaceClaim does work perfectly using solids, but this model consists only of zero thickness surfaces (baffles) and it doesnt work at all. Have anyone else experiensed this problem? //jackkra

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Error snappyhexmesh - Multiple outside loops	avinashjagdale	OpenFOAM Meshing & Mesh Conversion	53	March 8, 2019 10:42
[DesignModeler] what is the rule to choose periodic surface for a single flow passage of turbo model?	shivasluzz	ANSYS Meshing & Geometry	0	August 2, 2016 15:55
[DesignModeler] Sweeping or surface meshing in enclosure?	Edu-R	ANSYS Meshing & Geometry	9	January 23, 2013 14:41
Question about the best way to model water jet impingement on a heated surface	Rockda	FLUENT	2	February 27, 2011 10:52
Surface Tension Force Model	Miguel	CFX	7	October 2, 2006 06:30

December 10, 2016, 04:34		#2
Tscar Member Join Date: Nov 2014 Posts: 36 Rep Power: 11	Hi, I have the same problem right now. Did you find a solution? Thanks.

December 20, 2016, 08:14		#3
jackkra New Member Join Date: Sep 2016 Posts: 4 Rep Power: 10	I haven't found any solution to this issue yet. Anyone else? Tscar?