[wzhmanu]

Dear all,

I'm trying to do a structural simulation based on the temperature data from "Transient Thermal" on ANSYS Workbench. But I failed to load the temperature data in "Transient Structural" module, the error message says "An error occurred while trying to match source bodies: No matches were found within the specified tolerance."

I'm quite confused about the error message, why the "volume difference" is 200%, the model is tranferred and should be the same.

I can't load the data until I turn up the tolerance to 200%, but the results must be wrong.

Software version: ANSYS Workbench 17.0, model/mesh was done in ICEM CFD 17.0

Thanks for your time in advance.