 |
 |
 |
|
|
|
[Sponsors] | ||||
meshing error:the follwing faces have more than 1 external loop |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 30, 2015, 10:06
|
meshing error:the follwing faces have more than 1 external loop
|
#1 |
|
New Member
Chunze Wang
Join Date: Sep 2015
Posts: 7
Rep Power: 11  |
i used the meshing model in ANSYS Fluent, but it appeared an error :"the following faces have more than 1 external loop Bodies with these types of faces are not sweepable. please edit your geometry to split these faces into faces with single exterior loop.......". but i don't know where the error is. how could i do to resolve it?
hope to get your help! |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 09:54 |
| [Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 11:49 |
| SigFpe when running ANY application in parallel | Pj. | OpenFOAM Running, Solving & CFD | 3 | April 23, 2015 15:53 |
| snappyhexmesh remove blockmesh geometry | philipp1 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2014 11:58 |
| AMI interDyMFoam for mixer | danny123 | OpenFOAM Running, Solving & CFD | 4 | June 19, 2013 05:49 |
Linear Mode
