|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
suhag patel
Join Date: Sep 2015
Posts: 3
Rep Power: 10 ![]() |
hii ,
i found problem in doing cfd analysis of screw compressor , is there any right way to simulate it??? Last edited by suhagpatel; September 26, 2015 at 02:30. |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
suhag patel
Join Date: Sep 2015
Posts: 3
Rep Power: 10 ![]() |
hii,
I am doing analysis of screw compressor and want take male and female rotor solid but I dont want to involve them in meshing and further computation process. so please suggest any way to freeze/deactivate it. please suggest it as early as possible. |
|
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
suhag patel
Join Date: Sep 2015
Posts: 3
Rep Power: 10 ![]() |
hii,
I am simulating flow between two concentric cylinder with inner cylinder rotating using dynamic mesh model. I have few doubt which method of re-meshing is best? |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Screw compressor - How? | Roland R | CFX | 4 | April 10, 2018 02:52 |
Screw Compressor | Rohit Tripathy | FLUENT | 0 | May 5, 2013 07:00 |
Turbocharger Compressor Wheel CFD Analysis | aymen_a22 | ANSYS | 1 | April 20, 2013 10:39 |
[TurboGrid] Turbocharger Compressor Wheel Meshing | aymen_a22 | ANSYS Meshing & Geometry | 0 | March 20, 2013 10:27 |
Compressor Blade Analysis in Ansys CFX | LynchMobster47 | Main CFD Forum | 0 | April 10, 2012 22:43 |