ICEM->Fluent

wel · November 21, 2014, 12:21

Hey All,

I've been trying to import a mesh from ICEM to Fluent. The blocking and premesh is in 2D which was then converted to 3D by rotation. Importing into Fluent generates the following error:

***************
257148 nodes.
240673 mixed cells, zone 11.
703804 mixed interior faces, zone 12.
4541 mixed wall faces, zone 13.
3439 mixed wall faces, zone 14.
1102 mixed wall faces, zone 15.
25334 quadrilateral wall faces, zone 16.

Building...
mesh
Cell Centroid is xc -32.293785 yc 106.096443 zc 0.487752
WARNING: no face with given nodes. Thread 11, cell 57399

Clearing partially read grid.

***************

How do I get around this?

Thanks!

sache · November 28, 2014, 07:15

Have you checked unstructured mesh in icem for specific problems.
If not please chek for any problem, it might help you.

blgypeng · December 2, 2014, 07:02

maybe is the geometry problem.Before you converted 2D mesh to3D,make sure you geometry is fully.

November 21, 2014, 12:21	ICEM->Fluent	#1
wel New Member Welly Join Date: Nov 2014 Posts: 10 Rep Power: 12	Hey All, I've been trying to import a mesh from ICEM to Fluent. The blocking and premesh is in 2D which was then converted to 3D by rotation. Importing into Fluent generates the following error: ************* 257148 nodes. 240673 mixed cells, zone 11. 703804 mixed interior faces, zone 12. 4541 mixed wall faces, zone 13. 3439 mixed wall faces, zone 14. 1102 mixed wall faces, zone 15. 25334 quadrilateral wall faces, zone 16. Building... mesh Cell Centroid is xc -32.293785 yc 106.096443 zc 0.487752 WARNING: no face with given nodes. Thread 11, cell 57399 Clearing partially read grid. ************* How do I get around this? Thanks!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
PEM Fuel cell module meshes. ICEM vs workbench	aarvay	FLUENT	24	March 2, 2020 07:50
[ANSYS Meshing] Workbench 13: Structured Hexa Meshes	rooftop	ANSYS Meshing & Geometry	19	March 31, 2016 03:33
[ICEM] Different meshes from ICEM and GAMBIT	Mojtaba.a	ANSYS Meshing & Geometry	9	March 30, 2013 03:42
[ICEM] Meshing adjacent wall geometry and simple ICEM questions	everdimension	ANSYS Meshing & Geometry	25	June 20, 2012 05:25
Design Modeler to ICEM.....	Joe	CFX	0	January 24, 2008 04:39

November 28, 2014, 07:15		#2
sache New Member Join Date: Dec 2013 Posts: 17 Rep Power: 12	Have you checked unstructured mesh in icem for specific problems. If not please chek for any problem, it might help you.

December 2, 2014, 07:02		#3
blgypeng New Member liuyan Join Date: May 2013 Posts: 14 Rep Power: 13	maybe is the geometry problem.Before you converted 2D mesh to3D,make sure you geometry is fully.