fsi

sa har · August 19, 2014, 15:22

I have 2 mesh of gambit,a solid(airfoli)and a fluid gemotry.how can i use of them in ansys?i can import one of them in ansys.

Daniel_Khazaei · August 25, 2014, 04:57

Quote:

Originally Posted by sa har

I have 2 mesh of gambit,a solid(airfoli)and a fluid gemotry.how can i use of them in ansys?i can import one of them in ansys.

Hi sa har

You can import solid mesh using FE Modeler and then connect it to Ansys Structural. (Model Cell)

Best wishes

sa har · August 25, 2014, 10:32

thanks alot.
this error appears.i think i cant relate between solid and fluid.

error:the model is unconstrained or additional iterations may be needed.try running setting the multiplier MULT on the EQALV command to greater than 1.0.(but less than 3)

Daniel_Khazaei · August 25, 2014, 18:21

Quote:

Originally Posted by sa har

thanks alot.
this error appears.i think i cant relate between solid and fluid.

error:the model is unconstrained or additional iterations may be needed.try running setting the multiplier MULT on the EQALV command to greater than 1.0.(but less than 3)

How did you setup the project?
Project schematic image can help identifying the problem...

Furthermore, can you check the mapping summery?

Best wishes

August 19, 2014, 15:22	fsi	#1
sa har Member sa har Join Date: Aug 2014 Posts: 34 Rep Power: 12	I have 2 mesh of gambit,a solid(airfoli)and a fluid gemotry.how can i use of them in ansys?i can import one of them in ansys.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FSI: How to transfer static pressure from fluent to ANSYS	momo_sjx	FLUENT	0	October 9, 2012 14:37
BCs in an FSI simulation of a flexble pipe	vivekcfd	OpenFOAM	10	January 8, 2010 05:14
initial file for fsi modeling?	mortazavi	CFX	0	July 21, 2009 03:06
fsi	sun	Siemens	8	January 20, 2009 00:17
how to extend FSI 2D codes to 3D, need advises	abouziar	Main CFD Forum	1	May 30, 2008 05:08

August 25, 2014, 10:32		#3
sa har Member sa har Join Date: Aug 2014 Posts: 34 Rep Power: 12	thanks alot. this error appears.i think i cant relate between solid and fluid. error:the model is unconstrained or additional iterations may be needed.try running setting the multiplier MULT on the EQALV command to greater than 1.0.(but less than 3)