How to draw spiral tubes in Ansys Workbench

shufang · June 24, 2014, 21:45

Hi, I am new to ansys workbench.

My geometry is spiral tube attached to a cylinder's inner curved wall. I first draw a 3D curve similar to sin curve. Then use a circle to sweep via this 3d curve. But my problem is my spiral tube did not have the same shape. I mean, some part of the spiral tube exceeds the cylinder wall. I use the same standards to draw points and then create 3D curve. Could you help me find out what's the problem?

Thank you very much!

Mostefa · August 13, 2016, 04:29

you still need help?

June 24, 2014, 21:45	How to draw spiral tubes in Ansys Workbench	#1
shufang New Member Join Date: Jul 2013 Posts: 2 Rep Power: 0	Hi, I am new to ansys workbench. My geometry is spiral tube attached to a cylinder's inner curved wall. I first draw a 3D curve similar to sin curve. Then use a circle to sweep via this 3d curve. But my problem is my spiral tube did not have the same shape. I mean, some part of the spiral tube exceeds the cylinder wall. I use the same standards to draw points and then create 3D curve. Could you help me find out what's the problem? Thank you very much!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ANSYS Workbench on "Uncertified" Linux Distros	hsr	CFX	289	April 20, 2023 10:23
FLUENT installation on UBUNTU 12.04 (LTS)	teymourj	FLUENT	2	March 1, 2017 23:24
Macro command combatibility ANSYS workbench	Tassos	CFX	6	January 13, 2014 05:19
[ANSYS Meshing] How to draw ellipsoids in Ansys workbench	quarkz	ANSYS Meshing & Geometry	0	February 19, 2012 18:09
Ansys workbench problem	Jonny6001	ANSYS	2	September 30, 2010 13:59

August 13, 2016, 04:29		#2
Mostefa New Member Mostefa.A Join Date: Apr 2009 Posts: 9 Rep Power: 17	you still need help?