|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Chait
Join Date: Apr 2014
Posts: 14
Rep Power: 12 ![]() |
Hello All,
I am trying to use CFX v13.0 on CentOS 6.5. I have installed all the required libraries. However on trying to run CFX Pre, I encounter the following error message. ERROR CCL validation failed with message: Warning: Can't check parameter Message Type (/PHYSICS MESSAGES/PHYSICS MESSAGE:msg0000/Message Type): Can't find rule. I noticed that several other users have also encountered similar error, but could not find any specific solution. Has anyone been successful in running CFX v13 on CentOS 6.5? If so, I would greatly appreciate if you could give me some hints. Thanks! |
|
![]() |
![]() |
![]() |
Tags |
ansys 13, centos 6.5 |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Strange issue while launching ANSYS workbench in CentOS 6.4 | Philip_C | ANSYS | 11 | August 29, 2013 06:44 |
Installation of ANSYS 14.5 on Centos 6.3 | aks | ANSYS | 0 | August 27, 2013 02:47 |
How to open old mesh cmdb files in ANSYS CFX v13.0 ? | Sudharshani | CFX | 2 | May 12, 2013 22:13 |
how to read *.cmdb8 mesh files in ANSYS CFX V13.0 ? | Sudharshani | Main CFD Forum | 0 | May 6, 2013 23:01 |
Can't find Ansys workbench in CentOS | idil | ANSYS | 1 | October 11, 2012 08:44 |